Search results

Awesome job, well done!! Finishes look excellent. Have you learnt a heap with this one? And did you learn where you can save money next time? As for inspections/photos prior to finishing work, i think it depends on what work is left, if it'minor like a curtain in laundry not bad but if...

you have a challenge on your hands! Have you gone to a paint shop (not bunnings) and told them what your up against? Youll need an oil based for the walls if you havent already. might save a coat or 2 if your lucky. As for the cornice, get a spray gun if you can?? It will make it a lot...

Paint wise, depends what's there I'd say it's an old house so go oil based. Chances are the paint is oil that's there. And if it's in ok condition you could almost get away with one coat if done right,thick and minimal streaks. Painters don't recommend that though but they get paid to do it...

If the bowed wall is out by a fair bit say just through the middle you could pack the wall out in those sections then putup a new sheet over. You will need a lot of screws and make sure their long enough and that they are into timber

Can you upload a sketch of what's there note and what the plan is Try an old screw driver to get in under them and pop them out Out Get a brick bolster or chisel with a hammer and go nuts How much is the wall out by? A good tiller should be able to hide it? It it just bowed in the middle...

Call your sparky and plumber and play dumb and say there could be asbestos, your not 100% sure. See what they say, they probably work with a lot and won't be to worried. Or cut out the pp hole for them and remove sections where the tsps need to go. Just keep it wet when working with it. They...

Do you need to pull the sheets off in the kitchen?? Can you just patch and leave as is? Out just sheet over the walls. Best not to touch it if possible

Sounds like fun! I've just completed pretty much all the same as you have in your list. It was our ppor which makes it a lot harder. I reckon if you do all the work yourself out very little trades, you should be able to squeeze the deck in. I put two in, front and rear. I think it worked out...